Mini Trigger Sprayer Manufacturers introduces the common faults and troubleshooting methods in use:

1. Insufficient spray pressure and poor atomization: if the water inlet ball valve is put up by dirt, the water inlet valve can be removed and the dirt can be removed with a cloth; if the leather bowl is damaged, a new leather bowl can be replaced; If the sealing ring is not installed, or the air leaks due to the damage of the sealing ring, the sealing ring can be installed or replaced.

2. The spray cannot be fogged: If the inclined hole of the nozzle body is blocked by dirt, the inclined hole can be cleared; The hole is enlarged, which makes the spray quality worse; if the filter in the casing is blocked or the ball of the water-passing valve is put up, the filter screen and the dirt on the ball should be cleaned.

3. The switch leaks or cannot be screwed: if the switch cap is not tightened, the switch cap should be tightened; if the washer on the switch core is worn, the washer should be replaced; the switch cannot be screwed because it has been placed for a long time or has been used for a long time, the switch core is adhered due to the corrosion of the chemical, and the parts should be removed and cleaned in kerosene or diesel; if it is difficult to remove, it can be soaked in kerosene for a period of time, and then removed to remove, do not use hard objects to knock.

4. Water leakage at each connection part: if the joint is loose, the nut should be tightened; if the washer is not leveled or damaged, the washer should be leveled, or the washer should be replaced; if the washer shrinks and hardens, it can be immersed in animal oil after softening reuse.

Through the above introduction, Lotion Dispenser Pump Manufacturers hopes that you can simply refer to the content of this article in future use.